Blue FO Patch Cable OM3 1C 2C LSZH Length 20M 30M 50M Connector Type LC UPC

FO Cable OM3 1C 2C LSZH length 1M 10M 20M 30M 50M Connector type LC UPC

A fiber pigtail is a single,short,usually tight-buffered,optical fiber that has an optical connector pre-installed on one end and a length of exposed fiber at the other end.

The end of the pigtail is stripped and fusion spliced to a single fiber of a multi-fiber trunk. Splicing of pigtails to each fiber in the trunk "breaks out" the multi-fiber cable into its component fibers for connection to the end equipment.

Both Patch cord cable and pigtails can have female or male connectors. Female connectors could be mounted in a patch panel, often in pairs although single-fiber

solutions exist, to allow them to be connected to endpoints or other fiber runs with patch fibers. Alternatively they can have male connectors and plug directly into an optical transceiver.

The cable could be G652D, G655, G657, OM1, OM2, OM3, OM4 etc.
The cable size could be 0.25, 0.9,
There are 12 colors for your option.
Both 250um and 900um is same colored, easy to identify and make right splice.

High Quality and Cost-effective 9/125μm
SM Breakout fiber Pigtail
12 fibers/colored pigtail
It’s consists of 12pcs of Simplex pigtail.12pcs is a unit.Meets Telcordia GR-326 Core and ROHS requirements.
The connector could be SC, FC, LC, ST, MU, and E2000etc.
Tight buffer, semi-tight buffer. Loose buffer are available

Pigtails are used for splice applications when terminating outside plant cable. It’s consists of a connector and a special length

LC patch cord is a fiber optic cable used to attach one device to another for signal routing. LC stands for Lucent Connector. It is a small form-factor fiber optic connector, half the size of the SC.


UPC stands for Ultra Physical Contact.The end faces are given an extended polishing for a better surface finish. These connectors are often used in digital, CATV, and telephony systems.

APC stands for Angled Physical Contact The end faces are still curved, but they’re angled at an industry-standard eight degrees. This maintains a tight connection. These connectors are preferred for CATV and analogue systems.